Cannot find Firmware

[Joel Godin]

Hi, I want to get started on this project, but I cannot find the firmware.

Is the FlowDriver V3 open source?

Is there a link for the hardware and software for this driver?

Thanks

Joel

[luigi pacheco]

Any luck with this? 

I haven t been able to find any information on this, not even on the older drivers (v2 or v1)

[Ethan Frazin]

were either of you able to obtain firmware?

[cera.tops]

Hi all,

Unfortunately life circumstances have kept me from updating this project.  The flow driver software, while working well enough for me to use, is very buggy and chalk-full of problems.  I am not a professional programmer, and tend to write code that "gets the job done", but is far from perfect.

This is very much the case with the code for the flowdriver. That said, I will share the file with you (see attached), but I am not in the position to provide technical support for it at this time!

Best,
Bryan

[Ethan Frazin]

Thanks so much. I know firsthand how difficult it is to find time around jobs and parenting for pet projects. 

Care to share a BOM and a clipper for the v3 board, the board I and assuming others built is the v2?

[cera.tops]

I would guess they have built v2 - I never meant to even publish it. I started the process and decided against it, but never deleted the page for it. People have managed to find it via search engine (i assume?) and build it from there.  Crazy!