MKS V1.3 OPENPNP 翘翘板设置问题，无法正常运转求助

[guo feng]

大家好；

   先谢了，谁能协助看下我的设置文件，有否正确：1.因为运动有问题，有异响，物体没有卡主地方，附件还有设置文件：

2;如下不知道具体怎么设置：摆臂长度为:27MM, 3:回零后位置不是正中央平衡位置，有偏差：第二图片就是：

[simpl...@tuta.io]

your head is looking nice

the z-servo is configured correctly?

sounds like control loop error

sorry, can not help you with OpenPnP, i'm not using it any more since six years

but i would put the endswitch on one side minimum and make the fine adjusts with gcode commands before zeroing the z-axis

Aug 15, 2026, 09:22 by gfen...@gmail.com:

--

You received this message because you are subscribed to the Google Groups "OpenPnP" group.

To unsubscribe from this group and stop receiving emails from it, send an email to openpnp+u...@googlegroups.com.

To view this discussion visit https://groups.google.com/d/msgid/openpnp/21cf1a12-453e-44d0-896f-874df6a89176n%40googlegroups.com.

[guo feng]

限位开关位置，因为免费打样问题，侧面无法开孔，或费用很高，所以我改在正面了