Re: [OpenPnP] BTT SKR V1.4 or Due Marlin or Smoothie & Why ?

[Trinh Dinh Huu]

I have skr v1.4 tubo and update smoothie success. 

Vào 21:16, Th 2, 22 thg 3, 2021 Siddharth Valambhia <svala...@gmail.com> đã viết:

I had collected most of mechanical items and also electronics to build pnp.  I have some controllers with me like due and btt  skr1.4. I am planning to build one with BTT skr v1.4, unlike skr v1.3 it does not have smoothieware, but it came with marlin. I had asked btt for flash and config file or procedure but they said they don't have any.

I had notices some people in group have configured smoothieware on it. As I read some people says marlin 2.0 is better (it does have good support for 3dp but not much information on pnp) while some post on openpnp github says smoothieware is better. please suggest which is better and why ? 

I guess speed and functionality is key factor to choose firmware. 

--
You received this message because you are subscribed to the Google Groups "OpenPnP" group.
To unsubscribe from this group and stop receiving emails from it, send an email to openpnp+u...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/14990c62-20a4-4a65-83d8-3f3a4b65c225n%40googlegroups.com.

[Siddharth Valambhia]

Can you please provide procedure or files ? I had noticed skrv1.3 and skrv1.4 has different pinout.

[Trinh Dinh Huu]

I use Makr's fireware. 

Skr v1.3 same skr v1.4 and skr v1.4 tubo

Vào 10:21, Th 3, 23 thg 3, 2021 Siddharth Valambhia <svala...@gmail.com> đã viết:

To view this discussion on the web visit https://groups.google.com/d/msgid/openpnp/c45a608c-5c98-4e31-80dd-fc210ed07be4n%40googlegroups.com.

[Siddharth Valambhia]

which firmware you use  ? provided by bigtree tech for v1.3 on skrv1.4 ? Both v1.3 and v1.4 have same chip but  circuit pin out is different did you change the pinout etc ? and I would like to know the procedure Because I generally upload from arduino ide or hex file. did you just put firmware. bin into sd card ?

[Siddharth Valambhia]

Do you mean you use mks sbase firmware or firmware rovided by bigtree tech for v1.3 on skrv1.4 ? Both v1.3 and v1.4 have same chip but  circuit pin out is different did you change the pinout etc ? and I would like to know the procedure Because I generally upload from Arduino ide or hex file. did you just put firmware. bin into sd card ?