PLCBus is not working

[Bruno Domingues]

Folks,

I hope this e-mail finds you well.

I have doing some tests in 1-phase with OpenHAB + PLCBus binding and I'm sure that PLCBus side of things is working, because I already tested with a PLC-BUS II - 4830G controller.

I already gave full permission to USB controller (i.e. PLCBus 1141G) as showed:

crwxrwxrwx  1 bruno dialout 188,   0 Mar 19 09:37 ttyUSB0

Executing OpenHAB with one item configured:"

Switch Light_Garden_1 "Garden 1" <switch> (gGarden, Lights) {plcbus="D0 A1"}

Staring OpenHAB in debug mode, there isn't any ttyUSB0 error and I ca see these events of starting PLCBus:

10:20:41.461 DEBUG o.o.b.p.i.PLCBusActivator[:32]- PLCBus Binding startet

10:20:41.468 DEBUG o.o.m.i.i.GenericItemProvider[:334]- Start processing binding configuration of Item 'Light_Garden_1 (Type=SwitchItem, State=Uninitialized)' with 'PLCBusGenericBindingProvider' reader.

However, when I try to turn on a light I receive these events:

10:21:22.835 DEBUG o.o.i.r.i.r.ItemResource[:196]- Received HTTP POST request at 'items/Light_Garden_1' with value 'ON'.

that is ok, OpenHAB is receiving the command, however always get this error message:

10:21:33.355 ERROR o.o.b.p.i.p.AbstractReceiveFrameContainer[:76]- Error while parsing ReceiveFrame

Any ideas on what can be wrong in this configuration?

Best Regards!

-Bruno Domingues

[louis.da...@gmail.com]

Hello Bruno,

I have the same behavior with my PLC-BUS controler and I don't know why!

Sometime it works.

I'm looking for some information about this error but nothing!

Regards,

Louis

[louis.da...@gmail.com]

Just to add that the error only appears with the rules!

If there are no rules with plcbus, you can switch on and off an item without error!

Regards,

Louis