Mounting holes for Arduino and motor controller

[Edgar]

Dear all,

In the case of using two faders in the enclosure, the SVG file
describing how to laser-cut the top plate is called TopPlate-
TwoFaders.svg. I just wanted to mention that I haven't tested the
alignment for the Arduino and motor controller board because I mounted
them from the bottom in my design because they looked better. So, if
you are in doubt, please assume you should mount the Arduino and motor
controller to the bottom and use the upper design stored in TopPlate-
TwoFaders.svg. (Otherwise, if you try to mount the Arduino and motor
controller to the top plate, please let me know if they fit or send an
updated SVG file!)

Note that this doesn't concern at all the top plates in TopPlate-
OneFader.svg. I believe that they both allow everything to fit in the
enclosure.

Cheers!

- Edgar