"FAILURE_NO_COMMS"

[Trevor Aron]

Hello,

I am currently trying to use open dnp3. However, SelectAndOperate commands I have been sending keep failing. I am using PrintingCommandCallback::Get() to see the results of my commands, and I keep getting the error message "Recieved command result w/ summary: FAILURE_NO_COMMS". However, sometimes it goes through and works -- I am trying to figure out what the problem could be! If anyone has an idea that would very helpful.

Best,
Trevor Aron

[Trevor Aron]

I also want to note that the connection between my device and the master seem fine all the time. I am not sure why sometimes there is no communication on actions and other time there are --- if I do multiple of the actions in a loop usually one of them will go through, and the others will have no comms

[Trevor Aron]

Also, does someone know of anyway to make a callback so that if a command does fail it keeps trying?

[Daniel Evans]

I believe you are on a different branch and want the mailing list here:

https://www.automatak.com/opendnp3/

On Fri, Oct 14, 2016 at 6:23 PM, Trevor Aron <trevor...@gmail.com> wrote:

Also, does someone know of anyway to make a callback so that if a command does fail it keeps trying?

--
You received this message because you are subscribed to the Google Groups "open-dnp3" group.
To unsubscribe from this group and stop receiving emails from it, send an email to open-dnp3+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.