Fwd: FW: How_To_Create_Irregular_Surfaces

[Ali Dashti]

Dear Community,

I have just started using geomdl. I have some points and want to create a surface. I have seen examples here but still I cannot strat working efficiently with this wonderful package. These are my Points:

my_surf=[[1.,1.,3.],[2.,1.,4.],[2.,2.,4.5],[3.,1.,4.5],[3.,2.,5.],\

                  [3.,3.,6.],[4.,1.,3.5],[4.,2.,4.4],[4.,3.,4.4],[5.,1.,4.]]

I have also upladed a fig to show how my surface should look like.

I do appreciate any help in advance.

Cheers,

Ali Dashti

 

[Onur Bingol]

I think you need surface trims to generate something like this. You can also repeat some control points (some CAD software do this).

Onur R. Bingol, PhD

con...@onurbingol.net | https://onurbingol.net 

---- On Tue, 11 May 2021 01:57:47 -0700 Ali Dashti <alidash...@gmail.com> wrote ----

--
You received this message because you are subscribed to the Google Groups "NURBS-Python" group.
To unsubscribe from this group and stop receiving emails from it, send an email to nurbs-python...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/nurbs-python/CAL%2BcX9UPcis5f5Hr3QnVd%3DggKN%2B-oD9WzuL4xJj5dFtBaVPedQ%40mail.gmail.com.

[Ali Dashti]

Dear Onur Bingol,

I do appreciate your hint. But honestly I did not get it because I have just started using geomdl. Can you please explain how I can use surface trims? Is there any example like my case in your repository?

Thanks again for being that much supportive.

Regards,

Ali

[Onur Bingol]

There are some examples in the geomdl-examples repository: https://github.com/orbingol/geomdl-examples/tree/master/surface/trimming

---- On Wed, 12 May 2021 11:21:21 -0700 Ali Dashti <alidash...@gmail.com> wrote ----

To view this discussion on the web visit https://groups.google.com/d/msgid/nurbs-python/0b1641b8-8d03-4350-ab42-1d464efdff1bn%40googlegroups.com.

[Ali Dashti]

Thanks for the link. Sorry for my basic problems. In this example: https://github.com/orbingol/geomdl-examples/blob/master/surface/trimming/trim_single.py

from where I can find the ex_surface01.cpt? I tried to run it but I faced error.

Isn't ther simpler examples like my points?

Thanks for being that much patient.