No data on pipes 2 and 3

[Gordon Brown]

Hi,

Used the library to get two devices communicating successfully.  I now have 4 transmitters and 1 receiver (all using Arduino Uno).  Transmitter 0 is set to the receiver's pipe 0 address, transmitter 1 is set to the receiver's pipe 1 address and so on.  Transmitters 0 and 1 sent their data OK, but there is no data received from transmitters 2 and 3 (nothing coming through in the receiver's pipes 2 and 3).

I have checked all the addressing is correct and follows the format given in the datasheet (used the default addresses and those given in the MultiCeiver datasheet example).  I have enabled all the data pipes (register 0x02) and set the RX payload (registers 0x11 to 0x16).  To help debug, I've read back these registers and all is correct.

Does anybody know what extra I'm missing to enable pipes 2 and 3 or have any sample code I can check against.

Regards,

[johntech]

There is a library out there called RF24_master. Add it to your other libraries.

 In the examples you will find a sketch called "starping" 

 Load that up on 2 or more NRF setups and follow the instructions in the heading.

 They will be talking within seconds!!

John