Did anyone succesfully install networking NLD10 on Dell Precision 390.
During installation NIC and driver are not installed
Any suggestions.
Joop van Buuren
Can you run lspci pls to show us what the NIC is being reported as.
--
Mark Robinson
Novell Volunteer SysOp
One by one the penguins steal my sanity...
lspci shows Broadcom Corporation Unknown device 167a (rev 02)
Joop van Buuren
Ahh, then the chip is not know to any driver. If you find the numerical
ID using lspci -n and google for it you might find which driver it should
be.
Oh, yeah. This forum is really for the old NLD product. We should move
this to the SLED hardware forum...
can anyone give me a link which specifies the maximum RAM supported by each
version of SUSE operating Systems .
if this not the correct place to post a thread, then specify where i need
to post this thread .
regards
umesh
Opinions expressed above are not
necessarily those of Novell Inc.
For SLES 9 : http://www.novell.com/products/server9/kernel_limits.html
I would expect that the same limits apply for the other versions on the
same corresponding hardware
--
Hamish Speirs
Novell Support Forums Volunteer Sysop.
(Please, no email unless requested. Unsolicited support emails will
probably be ignored)