Re: Server donot start after change of pc

[Wallgames.com]

It could be one of several problems, including a damaged disk drive.

Which version of Netware are you using?

Is the server fully patched? Can you load the newer *.HAM drivers, such as
IDEATA.HAM in place if the old ISADSK.DSK driver?

-Bob Carroll

"mmeetald" <mmee...@no-mx.forums.novell.com> wrote in message
news:mmeetal...@no-mx.forums.novell.com...
>
> Last week my old server pc failled to start.
> I found another pc and swap the Hard disk .
> But unfurtunately I can not start. It does not mount volumes. After
> load ISADSK command it waits and give
>
> 1.1.65 Device # 0 ISA Type 047 (200000100) deactivated by driver due
> to
> failure
>
> and return to netwotk name
>
> Is there away to solve this . I dont have too much info about this
>
> MMD.
>
>
> --
> mmeetald
> ------------------------------------------------------------------------
> mmeetald's Profile: http://forums.novell.com/member.php?userid=13270
> View this thread: http://forums.novell.com/showthread.php?t=373137
>

[Wallgames.com]

Assuming nothing else has changed, it could possibly be a bad drive or
controller. Is it possible to move the drive to the second IDE channel?
This would require changing the driver load command to accommodate the
different port and IRQ.

-Bob Carroll

"mmeetald" <mmee...@no-mx.forums.novell.com> wrote in message
news:mmeetal...@no-mx.forums.novell.com...
>

> I have tried it. Now I can see the volumes but I can not mount them.
> It stacks when I
> mount.
> I tried vrepair as it says it found m&#305;smaches. But whwn try to
> erite them to disk system halted. Any reason or advice