Reset to factory settings

[Rubén Barriuso Pérez]

I had to reset to factory settings because I cannot change the state of gpio2.
Now, I dont have access to Netzer, and I dont know how I can download the firmware.

In this link http://www.mobacon.de/wiki/doku.php/en/netzer/resettofactory show that If the release is older that 1.5, I have to solder a 1K resistor. I dont know what my version is, I only know that the Netzer was bought 6 month ago, so I supose it has to have a newest version.

So, I think I have to upload the firmware via TFTP, is all right?

Thank you so much.

Ruben

[Sven Schlender]

Hi Ruben,

> In this link http://www.mobacon.de/wiki/doku.php/en/netzer/resettofactory show that If the release is older that 1.5, I have to solder a 1K resistor. I dont know what my version is, I only know that
> the Netzer was bought 6 month ago, so I supose it has to have a newest version.

Well it depends. Where did you bought it?

> So, I think I have to upload the firmware via TFTP, is all right?

Uploading the erase eeprom firmware is also possible with versions before 1.5. You could try to download erase_eeprom first and ask again if it fails.


Best regards,

Sven Schlender



----
MoBaCon
Sven Schlender
Rundkapellenweg 1
04249 Leipzig
Germany
Phone: +49 341 230 4126
Telefax: +49 341 230 4233

Internet: http://www.mobacon.de
EMail: kon...@mobacon.de
Skype-ID: sven.schlender
USt-IdNr. / TAX ID: DE 251339663