Strain Gauge Amplifier for USB-6009

[DANRFXz]

Hi,
 
I've built an experiment that uses a single strain gauge on a cantilever beam.  There are three of these beams, each with it's own gauge (350 ohm).  I need a signal amplifier/excitation device to power the strain gauges and give a working input to a USB-6009.  Does anyobdy have any recommendations on what we should be looking to purchase?
 
Thanks!!
 
 

[Bueller]

Hi,
 
Here's the <a href="http://sine.ni.com/nifn/cds/view/main/p/sn/n1:7689,n25:13/lang/en/nid/1036/ap/daq" target="_blank">product page </a>that has all National Instruments devices capable of strain gauge measurements.
However, I would like to point out that the SCXI version of the modules, requires an SCXI chassis , and the SCXI chassis is connected to a 68 pin DAQ device.
At the bottom of the product page, there's a phone number and a " Talk to an expert " links. I recommend using one of those to contact one&nbsp;of National Instruments Technical representatives.
&nbsp;
Regards,
Faris A&nbsp;
&nbsp;