Pixiewps Executable Not Found
Cora Auch
thanks WM this looks great! just tried it out, not sure if im choosing the wrong settings, but reaver always reports 'could not associate with AP' indefinitely, and stays at 0% forever. I know settings make a difference if WPS locking or whatever kicks in, but is there a "better" approach to using this through the module. More for anyone else who has tried, I know you're a busy bee.
Start bully, wait a few minutes. Quit using stop button at the top. Attempt to resume session, unable to due to above error. Tried 3 times with the same results and had to delete files via ssh to get a new session going.
I downloaded the latest wps mod in my nano. It says the depencies are installed but when I hit start the button turns orange for a few seconds and then resorts back to the green "start" button.. Nothing happens.. And all the log says is "wps not installed" I'm using wlan1mon as the interface.. Am I missing a step?
Wps.
First I go to my interface and use the default wlan1. I hit start monitor, it does its voodoo. I then go to scan results and again I use the default 15 sec, and I hit scan, it does its voodoo. The scan results are displayed. Nice. But why does every result say NO to Wps, when I know full well that besides my own router should have displayed YES. I'm looking at WASH on another BT5 laptop and I can see YES to WPS. So why are preliminary monitor scan results wrong?
Ok anyway that did not stop me.... I clicked my router, and whalla under the OPTIONS heading all the fields populated my router info lay, along with other obvious pertinent info... yay... so now under the second OPTIONS heading I hit the first one auto detect and the 3rd one use small dh. Also I thought I'd try ... run pixiewps, and display non critical messages. Blam! I'm ready I didn't bother with the advanced section, jus keepn it simple for now. I scrolled up n hit start. It changed red to stop.
So now it has been 40 minutes, and under the OUTPUT section all it says in faded gray.... wps is not installed... hmm refresh log? Nothing..... HISTORY section....
Zero.... refresh log? Again same nil. So mean while pineapple is blinking red like silly.... I'm going to bed... let's c what happens after 8 hrs, if I get a log or hit the bathroom n deposit one...
It's written in C so it can work with the WiFi Pineapple since it supports OpenWRT, what your gonna have to do is possibly use the -A switch to not associate with the network then run a aireplay-ng to do a fake association which will possibly fail but meh.
Try with bully installed on something like Kali Linux 2016.1 I have a video on the FreeCST link in my signature the other issue could be due to a low signal the network could be blocked by too many things which is giving you a bad signal to associate with the network.
Well sadly ive scoured the web and have not found anyone who got this to work, I think its sad that I spent 230$ and now all this thing does is blink lights... I cant tell from the output and layout of the modules that this was all done half assed, Explain to me how I have a WPS enabled router, but when I SCAN, and get results.. EVERY ACCESSPOINT says NO to WPS even the one sitting next to me.
I only failed associations with reaver and timeouts with bully. The nano will not associate with any AP at all. Also, even though there is no association the pin guessing starts and the same initial pin is tried over and over. broken?
The WPS module is not broken. You have to configure the target before clicking on start, otherwise, nothing happen. Some times, the output says WPS is not installed, which is not the case (I've to look into that).
ff7609af8f