Tab switching

[marianne...@gmail.com]

Hello, I have a question about tabs in the desktop version of MLO. I tend to have quite a few tabs open as routine and I flip between tabs often. However, when I'm doing that I constantly have to reset to the position that I left the tab in because MLO switches to expanded view every time when I go back to the original tab.

So, for instance, if I'm grouping a fiter by, say, urgency on a tab and I have only the max urgency expanded, and I go to another tab to check on something, when I go back to the tab I'm working on it presents as fully expanded.

Is there a way that anyone can suggest that keeps the a tab in the state that I left it in?

Of course this is more of an annoyance than vital, but when you flip between tabs as often as I do, it becomes really annoying.

[Stéph]

I hadn't noticed this before, because I have most Workspaces set up to "sync selection with first tab". I've just tested it, though, and found that even when a workspace is not set to sync selection, it follows any expansion of branches in the outline that I do in the first tab.  I agree that it would be better if the outline expansion was independent for each tab.