Creation Workshop install and monitor setup

313 views

Skip to first unread message

Bob Stockdale

unread,

Jan 4, 2015, 7:12:25 PM1/4/15

to muve-3d-su...@googlegroups.com

OK, the beast is assembled and up on it's legs. I downloaded Creation Workshop, it does not go through a normal install process but launches directly from the unzipped file, is this correct?

Also I'm not sure what settings to use for the second monitor(projector), the instructions are to 'enable as a second desktop', I have the choice to clone or extend the screen, or show the desktop on either monitor 1 or 2. So far Creation Workshop only shows one display available no matter what option I select.

I need to feed the beast some resin soon...

Thanks, Bob

mUVe 3D Admin

unread,

Jan 5, 2015, 10:53:33 AM1/5/15

to muve-3d-su...@googlegroups.com

Bob,

Yes, Creation Workshop is simply unzipped. Make sure you always run it as an administrator.

You want to enable the projector as an extended desktop in Windows, and set the resolution to what you want to print at. So if you have a 1920x1080 projector you'll likely want to set it to that.

Then you go into Creation Workshop and start configuring. There is documentation on Creation Workshop in the PDF that is in the root folder of the download.