mumax2

Hello everyone, I've been exploring discussions in the Mumax3 forums and noticed that most

Hi, I tested the case of the mumax built-in function between two touching layers and the case of

Hello everyone in the community! I am trying to reproduce the antiferromagnetic simulation from this

I am trying to reproduce the results from this thesis: https://scholar.google.it/citations?view_op=

We are running an FMR simulation but can't observe the resonance point in the results.

Hi, Running your code, for Dind=3.5e-3, the skyrmion seems to be so large that it touches the edge

Thanks for the reply sir Regards, Richelle On Thursday 7 November 2024 at 08:11:05 UTC+5:30 Josh

Hi, This is something you would need to do in external processing. You can save the full spatial data

Hi community! I am facing a simple question but I cannot figure it out. When I run my mx3 code, what

Respected sir Thank you for your response, Sir, i want to see the effect of temperature on switching

Hello Users, I am studying the FMR mode of YIG using MuMax3. When I run simulations at higher

Instead of 'go get', you could manually download the repo from GitHub and place according to

Hi, I would recommend you to install CUDA, try to run a precompiled binary and see if it works with

Hi I have following code. I am doing postprocessing to create the image attached here. I have done

Hi, Please see the attached mumax3 link. You will find the workshop, API,and theory related to mumax3

Hi I am simulating growth of domains under application of magnetic field. Below the code is for a

the image is as follows On Monday, October 28, 2024 at 5:09:26 PM UTC+8 Joyi wrote: Hi, I am trying

Hello everyone, I'm trying to create Néel skyrmions with different helicities in MuMax3.

Hi, Mumax scripts by default don't take input variables like that. However, you can get a similar

Hi, It is not possible. How much memory you use is going to be determined by your how many elements

Hello! I'm trying to reproduce the hysteresis loop described in this article. However, my

Hi Josh， Thank you very much for your help, I will try it and if it succeeds I will show it below. 在

HI, I had not installed some toolkits for the GPU. It's working fine after I did that. Best

Hi, Yes, an OVF requires a J value for each cell, as a part of the format. You can simply assign

Hi, this forum is dedicated to mumax, not micromagnetism in general, and might not be the best place

Hi, Complicated geometry in the stl format would essentially have the object as a cloud of points,

Hi, In general you should adjust your cellsize and gridsize to suit your problem. For a discussion on

Hi, Material parameters like the direction of anisotropy is set via regions. Regions are limited to a

Dear all, Thank you so much Prof. Josh for the reply on my last question with regards to domain wall.

Thak you so much Josh. On Friday, October 25, 2024 at 2:15:51 PM UTC+5:30 Diksha Prajapati wrote: Hi