Dear all, Sebastian,
I have a problem in below case, please review and correct, if anything missing ?
mcproxy downstream interface is not able to function on tunnel interface like pppoe mode
Details:
1.configure MCProxy with upstream as eth1 and downstream as wan-ppp0 (Where wan-ppp0 is PPPoE Client interface running on top of eth0)
2.start Multicast UDP stream from H2.
3.Start a multicast listener @H1 over the PPPoE-server end point connected interface.
4) Though i am able to see the IGMP Join, messages receiving at wan-ppp0 interface of mcproxy IFCONFIG Rx packats, the multicast stream is not reaching to H1. ( the route also updated in ip_mr_cache )
5) Wheras, in place of PPPoE tunnel between H1 and Router, if plain interface is used, then the Mcast route is forming successfully in Router and able to receive stream at H1.
Queries:
q1) Is there anything extra configuration to be done for this kind of tunnel interfaces ?
q2) Were there any latest patches to address this issue.
H1 =================================== Mcproxy/Router ====================== H2
(downstream)wan-ppp0/eth0 eth1(upstream)
pppoe-server pppoe-client mode
Stream Listener Stream-Sender
my mcproxy.conf looks as below:
protocol IGMPv3;
pinstace myProxy: eth1 ==> wan-ppp0;