You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to MoFEM Q&A
Sir/Madam,
I tried executing a mesh file of 2d geometry using the command ./run.sh -my_file paper_network.msh -saturated_conductivity 1.0. But an error keeps popping up. Strangely I was able to execute the same code for a previous mesh of rectangular shape. I have attached the errors shown in terminal for your reference.
Regards,
Sagar
meb...@gmail.com
unread,
Mar 4, 2020, 12:51:01 PM3/4/20
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to MoFEM Q&A
Everything is right except that for the mesh you are using the saturated conductivity is too high, and the computation simply diverges. You could start from 0.1 and run, it will run without problem. Then you could increase the conductivity, and see how high you could go.
Lukasz Kaczmraczyk
unread,
Mar 4, 2020, 12:54:34 PM3/4/20
Reply to author
Sign in to reply to author
Forward
Sign in to forward
Delete
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to MoFEM Q&A
Sagar,
If you like to higher saturated conductivity you have can make mesh denser, and/or reduce time step.