Can't print

[Peter Sr.]

my z is off it sits about 1 mm from bead is the a way to reset the firmwear so my extruder touches the bed?

[Dan Shoop]

I know there’s a thumbwheel on the Z carriage for the screw rod that can make some adjustments. Perhaps it’s too far “up” and can be cranked down slightly. It shouldn’t take much if that’s the issue. I’d make adjustments using fine increments and see if it makes a difference. It could be it’s cranked too high from where it can calibrate. 

-d 

-----

Dan Shoop

another mod-T owner

On Aug 29, 2018, at 7:07 PM, 'Peter Sr.' via MOD-t <mo...@googlegroups.com> wrote:

my z is off it sits about 1 mm from bead is the a way to reset the firmwear so my extruder touches the bed?

--
You received this message because you are subscribed to the Google Groups "MOD-t" group.
To unsubscribe from this group and stop receiving emails from it, send an email to mod-t+un...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/mod-t/53e14dd9-956f-4aa0-95e1-afb0c568d80a%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

[Peter Sr.]

thank you I will try that