One Immediate Solution to Energy Costs and Carbon Emissions

0 views
Skip to first unread message

Dominick Penny

unread,
Apr 23, 2010, 4:12:01 PM4/23/10
to Minnesota NCEC planner
1. SAVE MONEY BY ELIMINATING WASTED ELECTRICAL CONSUMPTION
THE PROBLEM: Most motorized home appliances (air conditioning units,
refrigerators, freezers, ceiling fans, washers, dryers, dishwashers,
pool pumps, vacuum cleaners, furnace blowers, etc.) operate most
efficiently when they're operating at full capacity. When they're not
working at full capacity they pull more energy than they use, wasting
the difference. And let's face it, rarely does any appliance or device
in your home constantly work at full capacity. In fact, the average
home in America today operates at a power factor of .77. That means
23% of the electricity being delivered to the home is being wasted by
the use of motorized appliances working at less than capacity.
SOLUTION: A Device that is now being manufactured that is a capacitor
which hooks up directly to your Main Power Box. This technology is
available now as a result of high rising costs of electricity and can
be found by searching the internet for energy saving devices.
POWER FACTOR OPTIMIZATION
This technology increases that power factor, in most cases, to .97 or .
98, therefore increasing the effective use of your electricity and
lowering your usage.
2. PROTECT APPLIANCES AND ELECTRONICS FROM THE DAMAGE CAUSED BY
VOLTAGE SPIKES
THE PROBLEM: Typical residential and light commercial power sources
allow literally hundreds of spikes and surges per day to reach
valuable, and often times sensitive, electronic equipment in your
home. These voltage spikes come from many different sources (motors,
power fluctuations, static electricity, lightning, etc.) but can all
cause damage to televisions, stereos, computers, DVRs, security
systems, cordless phones, florescent lamps, etc.
DUAL- MODE SURGE PROTECTION
THIS TECHNOLOGY operates in a dual-mode for surge suppression,
alternating between two different types of protection, depending on
the circumstances. In the standard mode, devices using this technology
uses MOVs (Metal Oxide Varistors) to act as a sort of "pressure relief
valve," diverting the surge to the neutral/ground lines. However,
should a massive surge (like the kind produced by a direct lightning
strike) attempt to pass through the device, it switches into fail-safe
mode, cutting off the flow of electricity and blocking the surge from
getting into your home.
THE BENEFIT: Works to divert countless surges trying to enter your
home, damage from these surges is kept to a minimum, prolonging the
operating life of your appliances and electronic devices.
3. PROLONG THE LIFE OF APPLIANCES AND ELECTRONICS BY REDUCING
ELECTRICAL "NOISE"
THE PROBLEM: Our homes, businesses and factories are filled with
electronic devices that generate "noise." It's this noise that's
responsible for that all-too-familiar static you hear on your home
radio receiver, the "hum" of a florescent lamp, or the "snow" you see
when a TV produces a weak signal. And those are just examples of the
electric noise we can see and hear. Imagine how much noise is coming
from everything else in your home that you can't see or hear. What you
also can't see or hear is the damage this noise does to switching
power supplies, causing premature failure. We noticed a big difference
right away. Our new TVs and computers are performing better, our
phones are clearer, and our electric bills are going down. Plus, it's
nice to know you're doing something good for the environment.
SOLUTION:
HARMONIC FILTRATION
Designed to filter harmonics and high frequency current (trash) from
the electrical environment, harmonic filtration reduces the potential
for leakage into the human environment and the creation of additional
trash in non-linear loads (televisions, computers, variable frequency
drives, energy-efficient lighting, etc.). This technology has been
around for nearly a hundred years, and has been in use by industrial
and utility companies for quite some time. However, only recently has
this technology become available on a smaller scale, FOR INDIVIDUAL
HOMES.
THE BENEFIT: By reducing the electrical noise and trash current in
your home, this technology helps protect the switching power supplies,
helping prevent premature failure and prolonging the life of your
appliances and electronic devices. DID YOU KNOW?

Electricity usage has increased by 60% since 1985 and is expected to
grow by an additional 45% by 2030.
The use of electronics within the American home has been growing at an
exponential rate and we are constantly demanding more and more of our
home's electrical system.
The price per kilowatt-hour has gone from an average of 2 cents to 10
cents over the past 40 years.
Energy and energy pricing are now seen as the most important issues
facing the U.S.
Our homes and businesses are filled with electronic devices that
generate "electronic noise" that is harmful to these very same
devices.
The noise created by these devices breaks down the switching power
supplies, causing premature failure.
This wasteful electronic noise drains more wattage than it uses,
adding unnecessarily to your electric bill.
Typical residential and light commercial power sources allow literally
hundreds of spikes and surges a day.
These spikes and surges shorten the lifespan of valuable and sensitive
electronic equipment.
The technology to counter the harmful and wasteful effects of spikes,
surges, and noise has been used by industry and utility companies for
years, but is only now practical for home use.

Is this technology right for your home? This technology will work in
any home, as long as you have a circuit breaker panel with breaker
switches and not the old screw in type fuses, and the unit will work
on any single-phase electric application for your home. Also, if you
say "yes," to only two or more of the following, then you could be
saving a significant amount of money on your electric bill right now!

Is your home over 2,500 square feet?
Is your central air conditioner / heat pump unit 3 years or older?
Is your forced air furnace 3 years or older?
Do you have a pool?
Do you have a well?
Do you use an air conditioner?
Is your refrigerator/freezer not EnergyStar rated?
Do you have more than one refrigerator/freezer?
Is your washer/dryer not EnergyStar rated?
Do you have a hot tub or Jacuzzi?
Is your dishwasher not EnergyStar rated?
Do you have a number of appliances in your home?

Q & A
Will this technology affect any of my appliances and their normal use?
No. If anything, your motors will run about 10% cooler, which is good
because heat is the enemy of a motor.
How much can I expect to save per month by using this technology? Your
savings will depend on the factors in your home - the size of your
home, the amount of inductive motor load, the amount you are paying
per kilowatt-hour for electricity, etc. However, generally speaking,
the average savings is somewhere in the 8% to 15% range, and in some
cases 25%, on your home electric bills.
How long will it take for this technology to pay for itself? This
depends on your individual circumstances, number and age of
appliances, electrical costs, and usage patterns, but most units are
paid for within 6 months to 2 years years.
Is this technology easy to install? Yes, but it must be installed by a
licensed electrician. Installation requires opening the electrical
panel, exposing potentially dangerous high voltage wires. The units
using this technology comes with complete installation instructions
and usually installs in about 15-30 minutes.
How long will the technology last? Different units may vary but
generally It has a predicted lifespan of over 20 years.
Why haven't I heard of these products until now? That's easy; two
words - "cost effectiveness." Up until recently, electric rates
throughout America were cheap, costing us 2, 3 or 4 cents per kilowatt-
hour (kWh). Now electric rates are anywhere between 8 and 14 cents per
kWh. In some places, the rate is over 19 cents per kWh. For example,
New York City is 22 cents per kWh and Hawaii is 33.5! At the cheaper
rates, Units for the individual home did not make sense. But at the
current rates, it makes all the sense in the world.
It's time to face the facts. Energy costs are on the rise, and the use
of electronics in our homes is growing exponentially. To add insult to
injury, every day, the appliances and electronic devices in our homes
are under attack from surges, spikes and electrical noise. The time is
now for a Whole House Energy Management System.
This technology is a clean power system based on the same technology
that has been used for years by big industry and utility companies.
This technology provides your home with:

Power conditioning abilities that translate directly into savings
An easy installation that creates immediate benefits
A cost-effective solution that is amazingly maintenance-free

YOU CAN FIND OUT MORE ABOUT HOW ENERGY CONSERVATION CAN BENEFIT YOU--
AT MY WEB SITE.

Secret For Generating Free Electricity: http://www.homeenergymi.tk/

--
You received this message because you are subscribed to the Google Groups "Minnesota NCEC planner" group.
To post to this group, send email to minnesota-n...@googlegroups.com.
To unsubscribe from this group, send email to minnesota-ncec-pl...@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/minnesota-ncec-planner?hl=en.

Reply all
Reply to author
Forward
0 new messages