Invalid DPMI installing Win98SE

[Oswaldo Caballero]

Hi,

I've tried to install Win98SE (clean install) in a DTK Pentium 200 MHz and
it freezes and shows errors: "Standar mode: Invalid DPMI return from
03F7:5FP92" ow "SUWIN.EXE provocó un error fatal" o "WSSETUP ha producido un
error".

What´s wrong? it´s a hadware problem?
Please, help.
--
Oswaldo Caballero Rodríguez
CR Informática
Tel: 094-2763989
Medellín, Colombia.

[Mike Burgess]

Oswaldo, see if this helps ...(see MSKB article below)
Standard Mode Messages
If you get any of the following error messages, remove any memory managers
(such as EMM386.exe, QEMM, or 386Max) from your Config.sys file, and then
run Setup again.

Standard Mode: Invalid DPMI return.
Standard Mode: Fault in MS-DOS Extender.
Standard Mode: Bad Fault in MS-DOS Extender.
Standard Mode: Unknown stack in fault dispatcher.
Standard Mode: Stack Overflow.

Windows 98 Setup.txt File
http://support.microsoft.com/support/windows/readme/98/setup.asp

Mike Burgess Microsoft MVP DTS
"Troubleshooting Self-Inflicted User Problems"
http://members.aol.com/Knows98/
Please post replies to this Newsgroup
[remove NO from email address to reply directly]

"Oswaldo Caballero" <osw...@impsat.net.co> wrote in message
news:ufZaDWhk$GA....@cppssbbsa02.microsoft.com...

[Oswaldo Caballero]

Thanks Mike,

Í tried your option without succes. But someone tell me that problems in DOS
Protected Mode Interface are due to memory or processor problems and he was
rigth. I changed the processor and the installation was without problems.

Thanks again,

Oswaldo
Mike Burgess <winh...@NOhome.com> escribió en el mensaje de noticias
#nywJAik$GA.251@cppssbbsa03...