Google Groups no longer supports new Usenet posts or subscriptions. Historical content remains viewable.
Dismiss
can not use atsp32 with dialer.exe
3 views
Skip to first unread message
Klaus Darilion
Nov 20, 2009, 10:00:14 AM11/20/09
to
Hi!
I am playing around with atsp32 sample. Building, installing and
configuration works fine. When I start dialer.exe, I can see the lines
offered by atsp32. But when I choose a line and press OK, dialer.exe
does not accept it, because next time when I enter the configuration the
line for phone calls is switched back to <automatic selection>.
Further, if I just try to dial, dialer.exe does not try to dial via the
atsp32 lines. So, what must a TSP support to get used by dialer.exe? I
saw that atsp32 sets numPhones=0 during TSPI_providerEnumDevices - might
that be the cause of the problem?
Thanks
Klaus
Klaus Darilion
Nov 23, 2009, 1:23:58 PM11/23/09
to
Klaus Darilion schrieb:
> Hi!
>
> I am playing around with atsp32 sample. Building, installing and
> configuration works fine. When I start dialer.exe, I can see the lines
> offered by atsp32. But when I choose a line and press OK, dialer.exe
> does not accept it, because next time when I enter the configuration the
> line for phone calls is switched back to <automatic selection>.
> Hi!
>
> I am playing around with atsp32 sample. Building, installing and
> configuration works fine. When I start dialer.exe, I can see the lines
> offered by atsp32. But when I choose a line and press OK, dialer.exe
> does not accept it, because next time when I enter the configuration the
> line for phone calls is switched back to <automatic selection>.
Just answering myself: dwPermanentLineID must be set in
TSPI_lineGetDevCaps().
regards
klaus
0 new messages