Carver Manuals

[Marilu Mandez]

Hiwe have just changed our caravan, and it has an old carver motor mover fitted, now although it seems to work ok in the dry and flat, the grit rollers keep slipping on the tyre when under even light pressure. I was hoping they would be adjustable. I have looked into replacing the rollers, but I want to make sure the gap to the tyres is correct, also there is no isolator as there was on my previous Enduro mover.

It will certainly be cheaper to get a local workshop to check it out and replace any faulty parts than buy a new one! As stated, it could easily be that the gap is wrong through tyre wear or underinflated tyres. Carver supplied a guage to enable the user to easily check the gap, so must assume that it varies easily. I have mine checked at the annual service.

At the Carver Center, we want to assist you with all of your technology needs. Below you will find a variety of guides, tutorials, and manuals to help you along the way. Currently, we are migrating all of our guides to a new knowledge base which can be found here:

I have a main sheet where the main project data is recorded that has 325 columns!!! with different manuals configurations ( Type, show_if, etc.). Well, now I need to insert one (or several) columns at the beginning of the sheet due to needs that arise in the project, and when I click Regenerate Scheme, most of the columns lose the manual settings (Type, Show_if, initial value, etc. ), with which I lose many hours of work.

Hello, good day. This is an issue with AppSheet because when you change the names, the configurations also change. However, I have been researching, and I have even written a book about it that is available on Apple Books, a standard guide for working with AppSheet.

But initially, your problem is that you input all configurations in the show If properties. Every time you regenerate, your configurations disappear, and the more columns you have, the more overwhelming it becomes, especially if you have to wait too long between saves, particularly if those configurations affect the app's performance. I suggest you try reading the book I wrote to improve productivity in your app. However, for now, I suggest you create a virtual column with the column property configuration, and then in the show If of each column, only put the name of the virtual column. When you regenerate, the virtual column won't disappear (perhaps only the content of the show If if you change its name), but it will be easier to input the configuration since you have it in the virtual column.

3a8082e126