Aomei Clone Windows 10 To Ssd

0 views

Skip to first unread message

Lorri Dent

unread,

Aug 3, 2024, 5:29:16 PM8/3/24

to maxfflexerpa

Boot into Windows Installer. However, when prompted, instead of clicking the "Install Now" button, choose the "Repair your computer" option. For example screenshots, refer to the "Solution 2" section at -recovery/fix-error-0xc000000e.html.

I had this issue too, I cloned my disk to a Samsung EVO 870 and it would boot one time then fail. Similar to user1247736 I found that the partition where Windows was installed was not C anymore. To fix this:

My SSD was labeled as H instead of C so I received a winload.efi error. The solution I found was to use the cmd on a repair install off a usb and then type, type bcdboot H:\windows (if H is your windows partition)

Also this might help you, I believe fixmbr is for mbr disks only not for gpt disks. Basically you have to assing a drive letter to the efi system partition using diskpart and then start the bootrec /fixboot operation from inside the partition. -to-repair-the-efi-bootloader-on-a-gpt-hdd-for-windows-7-8-81-and-10-on-your-dell-pc?lang=en

I had the same issue. Solution was to remove existing EFI partition via diskpart (in diskpart boot partition there was no EFI information in partition details).Exactly last response from user "topgundcp": -restore/175489-cloned-ssd-wont-boot.html

My suggestion is to delete then re-create the EFI partition then use bcdboot to create a brand new BCD, From Admin command prompt:diskpartselect disk 1select par 2delete partition overridecreate partition EFIformat quick fs=FAT32assign letter=Aexitbcdboot E:\Windows /s A: /f UEFImountvol A: \D

I started again, using diskpart clean, diskmanagement MBR, and making sure not to boot to the USB connected disk and all went well. I was using Clonezilla in beginner mode and in both attempts I selected to copy the main boot record.