SET ON ASME SEC IX

[Elavarasan Mech]

Dear All

As per ASME SEC IX Nozzle branch connection Set on which thicknesss consider for ( Nozzle or main pipe)WPS & WQT selection 

Regards 

ELAVARASAN

[venkateswara reddy Desireddy]

For set on joint branch pipe thickness should be taken for WPS. For WPQ branch OD and thickness essential variable. 

Regards 

D.V.Reddy

Sent from Outlook for Android

---

From: material...@googlegroups.com <material...@googlegroups.com> on behalf of Elavarasan Mech <elavaras...@gmail.com>
Sent: Saturday, October 18, 2025 7:51:28 AM
To: material...@googlegroups.com <material...@googlegroups.com>
Subject: [MW:35841] SET ON ASME SEC IX

 

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-weld...@googlegroups.com.
To view this discussion visit https://groups.google.com/d/msgid/materials-welding/CAJ9L4ym7crHij%3DVpKu%3DGgwWENPN1j1fR%2BhZyZZGCC2-OkgTFWQ%40mail.gmail.com.

[SENTHILKUMAR SWAMINATHAN]

Set ON - Nozzle

Set Thru - Shell

Thank you, 

Regards, 

S.SENTHILKUMAR

--

[Vishwas Keskar]

Pl refer ASME SEC IX 

It enlists in detail qualification / limits 

--

[james gerald]

For Set-on Nozzle,

For Base Metal Thickness consider shell/ reinforcement thickness welded to Nozzle Wall thickness.

For Weld metal Thickness (PWHT calculation) use below.

  For Weldolet connections see below.

According ASME Sec.IX,

Thanks & Regards

J.Gerald Jayakumar

0091-8838619635

To view this discussion visit https://groups.google.com/d/msgid/materials-welding/1842047748.2811220.1760770883040%40mail.yahoo.com.

[Ramamoorthi Thangarasu]

Hi

Set In  mostly used for High pressure system it's considered mother pipe thickness only (bevel to be make only mother pipe)WPS and WQT selection to be select mother pipe.

Note if Set On Fillet  weld only applicable,no need to check size and thickness.

Regards 

Ramamoorthi Thangarasu 

DNV- GL

--

[Anandhapadmanabha pillaim]

While considering the thickness, if it's a dissimilar thickness, the thickness of the smaller one and upper one should fall as per QW-451.1 if the qualification is made on a 38mm thickness coupon, the upper limit you will get unlimited still the lower one should fall within the WPS or you can combine 2 PQR and make one WPS inoder ro cover upper as well as lower limit.

--