API 650 SS OR CS TANK INNER BOTTOM HEATING COIL RT PERCENTAGE

[GS BOOMIK]

Dear All 

Please can explain the tank inner pipe standard for as per api 650 or asme B31.3 and radiography percentage ?

[Rameshbabu B]

Let me know the inner pipe function??

On Mon, 13 Jun 2022 at 08:53, GS BOOMIK <boomi....@gmail.com> wrote:

Dear All 

Please can explain the tank inner pipe standard for as per api 650 or asme B31.3 and radiography percentage ?

--
https://materials-welding.blogspot.com/
https://www.linkedin.com/groups/122787
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-weld...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/materials-welding/CABbsZikNmPtJBAQWfAOnupsTe8WRQbgBvAieRoM7i%3D8JdvRv5Q%40mail.gmail.com.

--

Regards
Ramesh Babu Balaram
Head QA/QC
Zetwerk Manufacturing Businesses Private Limited
Mobile: +91 98 4 053 13 55

>>>DONATE NOW<<<
SUPPORT ZETWERK’S CAMPAIGN TO FEED THE VURNERABLE MIGRANT FACTORY WORKER POPULATION.
Contribute generously. Each donation will go towards essential ration kits.
Let’s come together as a nation so that they don’t have to go hungry

This information may be confidential and/or privileged. Use of this information by anyone other than the intended recipient is prohibited. If you receive this in error, please inform the sender and remove any record of this message

[Sham Shahabuddin T I]

Dear All

It is for sure API 650 Code is not applicable for the internal piping. As Mr. Ramesh said it depends upon the application of the piping. Mostly pressure piping code ASME B31.3 will be used, Still the application of the piping should be considered and the design engineers decide the governing code for it's construction and testing.

Regards

SHAM 

[JOEL REMOROZA]

Dear Ramesh,

Please check with your project specification requirements, it should be mentioned the applicable standards, whether ASME B31.3 or 31.1 and alike.

Below is an excerpt of the previous project, as a minimum RT shall not be less than 10%

Kind Regards,

Joel Remoroza

https://groups.google.com/d/msgid/materials-welding/6f86e06f-a526-4078-9370-71a20ab15713n%40googlegroups.com

.