Any design that runs for a few hours for me seems to X or Y-slip a few mm after a few hours in. I'm attaching a picture of a "pencil holder", I've tried printing about 10 times and only had it work once. The arrow points to the place where the printing shifted a bit. The quarter is for size reference. If I grab the design while still printing, it's firmly attached to the bed (PLA), so it's not an adherence problem. I can't catch it in the act (over several hours) so I'm not sure what's happening. I was wondering if anyone else has solved this problem. I have the M2.
--
You received this message because you are subscribed to the Google Groups "MakerGear - Make Today, Change Tomorrow" group.
To unsubscribe from this group and stop receiving emails from it, send an email to makergear+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.