MakerGear - Make Today, Change Tomorrow

Hi Rick, The last print from the old spool went great, then I had to switch to the new spool with

quick question, Is this the proper configuration for the parallel to series wiring: (PSU terminals

This ESD warning only applies to machine shipped between Aug/Sept 2013 and early February 2014. If

I have a makergear mendel that i finally just finished(after work and life etc got in the way for 6+

It lives! It turned out its first working print on Sunday. Turns out I put it away in much better

How do you identify a 12v vs 24v bed? I got it working by hooking up a 12v supply to the bed heater

If the only thing you've changed is a different roll of the same brand of filament, the problem

Filament cost is deep in some menu. Try machine settings or preferences, I don't remember right

If it helps anyone: I was having the same problem as Gary and was able to resolve it by installing

Howdy! I'm trying to troubleshoot a Mintemp error I've received. I'm reading 5v, 40kohms

Hi James, You should head over to the forum on http://forum.makergear.com/, that's much more

Dollar store pump spray hair spray look for acrylates in it. spray into a paper towel and wipe onto a

Not sure if this will help..... but the power connector on the RAMBo board has 3 pairs of inputs. The

Howell, MI May-September Green Valley, AZ Oct. - April​ Gary Make Better Things Make Things Better On

Still doesn't work On Monday, March 16, 2015 at 5:59:42 PM UTC-7, ketil wrote: It always says SD

We use an M2 to trail our materials during development. So we're pretty sure they all work well.

What do the gear marks on the filament look like once you retract it out? If it is squishing the

MakerGear.com and forum.makergear.com are intermittent at the moment. The web host says they are

3DXTech has launched two new grades of carbon fiber PLA and ABS - called 3DXMax™ CFR. The data will

Bryan and Jim, thanks! I ran the experiment again and that was the answer! Turning on some destring

Yan Zhuang, I'm going to assume you are a new M2 user, trying it out for the first time. If I am

Chris, You'll get way more help if you post over on forum.makergear.com --- pretty much everybody

yan, your going to have way more responses if you post on the makergear forum. there arent too many

Very nice. I like the simplicity of the original design + bowden. :) On Tue Nov 25 2014 at 2:19:04 AM

Hank - thank you for taking your M2! Rick -- Rick Pollack MakerGear 23632 Mercantile Rd. Unit G

http://forums.reprap.org/read.php?262,434083 суббота, 29 марта 2014 г., 9:29:51 UTC+4 пользователь

Nic, that's what I use for my 5lb spools. I have two tubs -- each holds 3 spools (just barely) On

I can extrude UV-stabilized MG94, black only. $30/kg shipped CONUS, 1.75mm. Up to about 20kg worth.

Hi. We updated our pricing on polyimide to reflect some improved pricing from our supplier. Since we

Remember to calibrate it when hot since the bed expands and the hot end extends when hot. On Sun, Oct

That is sort of what I figured might be the case with airwolf...nice to get a reality check. lol On

Apologies if this isn't sufficiently on-topic: Has anybody else here tried the surface from

OK, after about 12 hours of searching, I found a very strange solution. Oddly enough, I got the