REPLICATOR CAN'T FIND PORT TO USE
Nancy Ivette
to my computer (win7) it tried to find the device but now the makerbot
shows up and says that the device could not start (code 10). The
ReplicatorG also cannot find a port to use. I don't know if maybe I
connected some cables wrong, the ones that come from the big motor to
the axis drivers. Please Help :)
Luis E. Rodriguez
--
You received this message because you are subscribed to the Google Groups "MakerBot Operators" group.
To post to this group, send email to make...@googlegroups.com.
To unsubscribe from this group, send email to makerbot+u...@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/makerbot?hl=en.
Mark Cohen
Sent from my iPhone
Nancy Ivette
mega 2560. In the ReplicatorG I have also been able to select the
machine type but when I go under serial port, none show up. When I try
"upload new firmware", the uploading goes fine until it tells me to
select a port to connect to and there is no option to select. I
randomly clicked and it went to the part where I can upload and reset
and I tried that and nothing happened. I'm guessing I do need to
select a port before I try resetting but I can't seem to fix that
problem. The ReplicatorG continues to say that it cannot find a port
to use.
Extra info: I am using a windows 7 computer.
I've tried connecting the USB to every USB port but nothing has
happened.
I also am my sure of I possibly plugged in all the cables correctly
for the big gray box motor that features a 20pin connector since the
instructions were very vague about that.
On Jan 30, 10:27 pm, Mark Cohen <markcoh...@gmail.com> wrote:
> You need to pick the driver and the comm port number in the software.
>
> Sent from my iPhone
>
Dan Newman
On 30 Jan 2012 , at 7:47 PM, Nancy Ivette wrote:
> I have tried downloading all te appropriate drivers for the adruino
> mega 2560. In the ReplicatorG I have also been able to select the
> machine type but when I go under serial port, none show up. When I try
> "upload new firmware", the uploading goes fine until it tells me to
> select a port to connect to and there is no option to select. I
> randomly clicked and it went to the part where I can upload and reset
> and I tried that and nothing happened. I'm guessing I do need to
> select a port before I try resetting but I can't seem to fix that
> problem. The ReplicatorG continues to say that it cannot find a port
> to use.
>
> Extra info: I am using a windows 7 computer.
> I've tried connecting the USB to every USB port but nothing has
> happened.
> I also am my sure of I possibly plugged in all the cables correctly
> for the big gray box motor that features a 20pin connector since the
> instructions were very vague about that.
Make sure that you are connecting to the USB port of the Makerbot Motherboard (v2.4)
and NOT the USB port of the extruder controller. (You only plug USB into the
extruder controller when you wish to upgrade its firmware.)
Dan
Zip Zap
From: Dan Newman <dan.n...@mtbaldy.us>
To: make...@googlegroups.com
Sent: Monday, January 30, 2012 11:00 PM
Subject: Re: [MakerBot] Re: REPLICATOR CAN'T FIND PORT TO USE
You received this message because you are subscribed to the Google Groups "MakerBot Operators" group.
To post to this group, send email to make...@googlegroups.com.
