Replicator 1 + MakerWare - HPB setting doesn't stick in S3G or Gcode

[Will Smith]

Hey all,

When I print something using Makerware on our Replicator 1 (dual) using the PLA profile, the Gcode and S3G files don't seem include a line to set the HPB temperature. I've had really good luck getting PLA to stick to Kapton tape at 60C, but I can't get MakerWare to set the build platform temperature properly. I can have MakerWare write Gcode, make the change manually, and convert it to s3g using Replicator G, but that's kind of a pain.

My question is can I change the material profile to ABS in MakerWare without causing any problems?  What else does flipping that toggle do when Miracle Grue is slicing the model? Or is it better to either use ReplicatorG or make the change manually until this bug is fixed.

I'm using the 6.2 firmware on the Replicator 1 Dual and the latest version of MakerWare (1.02.16). Thanks for your help!

///Will

[Eighty]

You can look this stuff up on http://replicat.org .  Here's an excerpt.

 

 

• M101 Extruder on, fwd
• M102 Extruder on, reverse
• M103 Extruder off
• M104 Snn set temperature in degrees Celsius
• M105 get extruder temperature
• M106 turn fan on
• M107 turn fan off
• M108 Set Extruder's Max Speed (Rnnn = RPM, Pnnn = PWM)
• M109 Snnn set build platform temperature in degrees Celsuis
• M110 Snnn set chamber temperature in degrees Celsius
• M120, M121, M122 Snnn set the PID gain for the temperature regulator (not currently supported by ReplicatorG)
• M123, M124 Snnn set iMax and iMin windup guard for the PID controller (not currently supported by ReplicatorG)
• M128 get position
• M129 get range (not currently supported by ReplicatorG)
• M130 set range (not currently supported by ReplicatorG)
• M200 reset driver
• M202 clear buffer (not currently supported by ReplicatorG)
• M300 Snnn set servo 1 position
• M301 Snnn set servo 2 position