Full Enclosure and Colored Panels for MakerBot Replicator 2!

[Colter Fragale]

We decided to relaunch this project, now that more users have Rep 2s and since we are fully set up and ready to produce.

https://www.kickstarter.com/projects/46948321/full-enclosure-and-colored-panels-for-makerbot-rep

Thanks
Colter
Additive Solutions

[mfitz73]

I thought pla printed better in a cooler temperatures, thus making it fully enclosed would keep temps higher?
so which is it??

[Ryan Carlyle]

Big, fast PLA prints might benefit from an enclosure. Small ones or slow ones do better cooler though.

[Colter Fragale]

Depends on the temp of the room you are printing in. The room I had started printing in was 73 degrees and the warping was pretty minimal. When I moved down in the basement garage, it got down to the low 50s and the warping was pretty extreme.

[Joe Brunson]

You can get it a lot cheaper on eBay with a fan for about $129.00