Problem...
pa3gcu
> Hi!
>
> I try to get the AX.25 functions to work on my Linux box, but I've got
> some problems...
>
> I have compiled the kernel (2.4.18) according to the AX25 HOWTO. The new
> kernel boots fine. I have compiled and installed libax25-0.0.10.tar.gz,
> ax25-tools-0.0.8.tar.gz and ax25-apps-0.0.6.tar.gz according to the AX25
> HOWTO.
>
> I then edited the /etc/ax25/axports to look like
>
> ax0 SM0RUX-2 9600 255 7 144.950 MHz
> ax1 SM0RUX-7 9600 255 7 433.xxx MHz
> sl0 SM0RUX-11 38400 255 7 SLIP
>
> My TNC is a dual port KPC-4 connected to COM1.
>
> Then I enter "/usr/sbin/mkiss -s 9600 /dev/ttyS0 /dev/ptyq0 /dev/ptyq1"
> without any error messages (without any messages at all).
>
> The I enter "/usr/sbin/kissattach /dev/ttyq0 ax0 44.140.16.35" but get an
> error message like:
>
> kissattach: Error setting line dicipline: TIOCSETD: invalid argument
> Are you sure you have enabled MKISS support in the kernel
> or, if you made it a module, that the module is loaded?
And.?? Do you have "mkiss" support compiled into your kernel or is it a
module, ?? looks like its a module so you need to load the module beforehand.
'modprobe mkiss' ?????
If that fails then you possably do not have the required kernel configuration.
Check /usr/src/linux/.config for MKISS you could try;
cat /usr/src/linux/.config | grep MKISS
You should get CONFIG_MKISS=m or CONFIG_MKISS=y if you get
# CONFIG_MKISS is not set
that means you dont have mkiss at all.
> Any ideas?
>
> Pontus/SMØRUX
>
--
Regards Richard
pa3...@zeelandnet.nl
http://people.zeelandnet.nl/pa3gcu/
-
To unsubscribe from this list: send the line "unsubscribe linux-hams" in
the body of a message to majo...@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html