Physical separation in debris formation

[Nikesh Kumar Ojha]

Hello all,

I am simulating debris formation in target plate using hypervelocity impact. I observed there is a physical separation in debris (Screenshot attached) during simulation. I want to know why this separation occurs in debris. Is my debris formation is correct or there is any error?

Please share your valuable suggestions. Your suggestions will be highly appreciated.

For reference: Keywords attached

*CONTROL_SPH
$#    ncbs     boxid        dt      idim   nmneigh      form     start      maxv
            1            1     1.0E20         3       150                0          0.0      1.0E15
$#    cont     deriv       ini     ishow     ierod     icont     iavis     isymp
             0           0            0         0            0           0            0         100
$#    ithk     istab        ql         -   sphsort      
             0         0         0.01      0         0

*SECTION_SPH_TITLE
sph_projectile
$#   secid      cslh      hmin      hmax    sphini     death     start   sphkern
              3       1.2          0.2         2.0          0.0       1.0E20     0.0         0

Regards

nikesh