Mobile Air device and meshing

31 views

Skip to first unread message

RobC

unread,

Aug 14, 2025, 2:28:42 PMAug 14

to Loxone English

Hi,

I’ve started using the config myself rather than the original installer/partner and have a question about air devices and meshing.

The setup is on a long thin plot with two air bases and three tree -to-air bridges.

I have a Wrist Button Air that is used as an emergency alarm switch for my elderly mother-in-law who lives at one end of the plot.

I paired the wrist button with one Tree-to-Air bridge but the trigger only works when in the vicinity of that one bridge.

The two air bases are on the same channel as the bridge and I had thought the mobile wrist button would hop from bridge to base and back again as we roam around, but it doesn’t appear to connect to anything other than the one bridge.

Note the other bridges are dedicated to other air devices so they are not on the same channel.

I have tried to send the air bases and the one bridge a ResetNetwork command but not sure this is doing anything.