Skip to first unread message
Rob_in
Jun 19, 2019, 4:27:58 AM6/19/19
to Loxone English
Hi all,
As far as I can tell there is no 'Cooling Curve' block to get the Miniserver to work out a cooling system's setpoint based on target & outside temperatures (and the slope/offset parameters).
Basically, the opposite of a heating curve?
I have managed to create one from taking a heating curve block and adding a bit of logic either side but it's hardly nice.
Our current setup uses an Intelligent Room Controller linked to a Climate Controller, but this (the Climate Controller) seems nothing more than a glorified on/off switch as it doesn't calculate setpoints and that has to be done manually in external logic. Fine for heating, but slightly convoluted for cooling as discussed.
This just doesn't seem to be very logical. Have I missed something?
Cheers,
Robin
As far as I can tell there is no 'Cooling Curve' block to get the Miniserver to work out a cooling system's setpoint based on target & outside temperatures (and the slope/offset parameters).
Basically, the opposite of a heating curve?
I have managed to create one from taking a heating curve block and adding a bit of logic either side but it's hardly nice.
Our current setup uses an Intelligent Room Controller linked to a Climate Controller, but this (the Climate Controller) seems nothing more than a glorified on/off switch as it doesn't calculate setpoints and that has to be done manually in external logic. Fine for heating, but slightly convoluted for cooling as discussed.
This just doesn't seem to be very logical. Have I missed something?
Cheers,
Robin
Reply all
Reply to author
Forward
0 new messages