LoxConfig beginners troubles

[Michael]

Hi,

So I have just gotten my electrical installation to a point where I can start to program the miniserver.

I did a few push buttons in the kitchen, but forgot to set the room and category.

I have now updated the info and saved it in the mini-server, but this information is not updating on the web page or app.

Is there something I'm overlooking? New rooms where I set this before saving it shows fine in the app.

I could probably delete the page and do it again, it's only a few push buttons, but for my understanding, is there something I'm missing?

Sincerely

Michael

[Patrick Van Rie]

Did you check the property "Use" under "User interface" of those push-buttons? You can do the same in the properties of the corresponding digital output.

Op woensdag 30 december 2015 20:21:51 UTC+1 schreef Michael:

[Santeri / Finlandia Automation Ltd.]

Did you mean that the buttons show in the wrong category in the app? If so you need to change the room and category for every single input/output on that page. You need to set the room and category for the page (these will be given to all functions dragged to this page) and also everything you already put into that page. Hope this was understandable :)

Santeri

[Michael]

Hi Guys,

Thanks for the input!

It helped me figure it out.

So my logic is now: iif you set the room and category on the page, push-buttons etc. inherit this, but if you change it on the page after adding eg. push-buttons, they keep their settings, and you have to set them individually.

Michael

[Simon Still]

On Monday, 4 January 2016 15:59:35 UTC, Michael wrote:

So my logic is now: iif you set the room and category on the page, push-buttons etc. inherit this, but if you change it on the page after adding eg. push-buttons, they keep their settings, and you have to set them individually.

You can also get some 'stickiness' with the Lighting Controller labels - I found the easiest solution was to delete the block and add it again.