Loxone Remote Air Fun

[sk12345]

I just bought a Loxone Remote Air as a really fast way of switching the house alarm on and off and setting lighting scenes in the bedroom when half-asleep.  

The documentation was a little lacking on the config side though... in fact there was none.

Does anyone have a better way of translating the AQ message from the remote than what I did below?

Once attached to the airbase I ended up attaching a binary decoder block to translate the output in to the five separate sates and then attaching them to digital memory flags for use across the config..  

Am I missing something?  Being a Loxone product there must be an easier way of telling config to decoder it than using this block?

thanks.

[David]

Hi sk12345,

I think I understand what you are asking.

Tyr clicking on the remote in the Periphery tree - then in the properties of that device you can check which buttons you want to show. 

Each of these then shows up in the periphery tree and can be dragged into the config as an input. 

Hope that makes sense

Cheers Daivd

[sk]

yes that's exactly what I was expecting!! thanks! Out of practice on config.