Lighting controller issues with Loxone 16

[Russ]

Hello,

Ever since the Loxone 16 firmware upgrade we've had strange behaviour with our lighting. We have a momentary switch into the M+ input to move between scenes which control wall spots and RGBW Led strips.    Double click for all off as per usual.

After the update, the moods are not consistent and double clicking does not always result in all off. It feels almost like a mix function is on (although Mmd is set to 0). 

In the Loxone app, I get better results if I use the More page to move between scenes; selecting scenes from the list often has behaviour similar to the momentary switch.

I seem to remember there was once a firmware upgrade that required updating controller blocks, but I didn't see anything like that with 16. 

Anybody else see this or have any suggestions?

Thanks

[Russ]

Just to close this off, I discovered the problem. It wasn't Loxone that was causing the issue, it was a Chinese RGBW Led dimmer that was throwing out a lot of noise and messing up the dmx signals. I disconnected the ground (thanks ChatGPT), and that solved it. Troubleshooting involved buying a DMX analyzer (Botex Dr RDM) which turned out to be a very handy piece of kit.