Touch Surface Decal / graphics NOT as .dxf

[Ole Larsen]

Anyone got a graphics file outlining the touch-points, which can be used for a vinyl cutter machine? 

The original decal has very poor adhesion on a Dekton tabletop so lasted around a week before it was gone...

Cheers

Ole

[Ewan Tait]

Loxone have a DXF file:

https://www.loxone.com/enen/kb/touch-surface-tree/ (at the bottom, "milling template")

Cheers,

Ewan

[Techdoctor]

Is it possible to engrave the touch points into the Dekton. Just a thought. 

[Mark McCall]

Our Dekton was engraved with the Touch Surface template.

--
You received this message because you are subscribed to the Google Groups "Loxone English" group.
To unsubscribe from this group and stop receiving emails from it, send an email to loxone-englis...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/loxone-english/f808c51b-b80c-4deb-9262-909cf6635e60n%40googlegroups.com.

[Johnny]

It looks great, did the Kitchen company do these for you or how do you engrave it?

[Mark McCall]

Yes, kitchen folk sorted with instructions from our Loxone partner / installer.

M.

To view this discussion on the web visit https://groups.google.com/d/msgid/loxone-english/b6fec255-8683-478b-b339-cae4b514a8c7n%40googlegroups.com.

[Rob.no1]

We also had the worktop company engrave our Dekton, we omitted the LED Holes as I was worried about them filling with dirt etc, but slightly regret it now!

[Simon Still]

Whats the experience of actually having that touch area on a worktop?  It felt to me that it was likely to result in a load of accidental triggers if you used the worktop for anything (and there are loads of places you could affix a wireless touch air switch  that wouldn't share the same issues)

[Mark McCall]

No issues with false triggers (you have to activate it, then touch). Wish I had put one in the shower too.

M.

To view this discussion on the web visit https://groups.google.com/d/msgid/loxone-english/f204f39e-0b3c-4600-8be6-83ba26c9132dn%40googlegroups.com.

[Rob.no1]

out of interest how have you all attached your touch pads to the under side of the worktop? Ours feels quite a rough surface and loxone say to ensure there are no air gaps between the surface and the pad? 

I have fitted one in a wet area behind a tile and did get some false inputs, but that was when I removed the activation button, since I have added that back into the software it seems to work ok... 

Kind Regards

Rob