Different mood night time

[Chris Pitman]

Hi

I have loxone controlling via dmx some light strips in cupboards during the day they are set at like 95% on the lighting controllers but if opening at night its light someone putting a torch in your face I have a 'night time' mode which deactivates some of the room PIR's bringing the lights on. 

I attached the config pic whats the easiest way to have two moods based on using the 'night time' mode? Looked at the Motion input but can't get it to work with this setup is there an alternative way?

[Tomasz Nowak]

I would use the Mv input for the I2. Why exactly it doesn't work for you?

After triggering the Mv you may use a different Mood in Automatic tab of your cupboard Lighting Controller setup for Night time mode.

You might also skip the reset delay block then and use MT parameter instead.

T.

[Rob_in]

On Thursday, 2 April 2020 02:05:08 UTC+2, Tomasz Nowak wrote:

I would use the Mv input for the I2. Why exactly it doesn't work for you?

What he said. Just connect the cupboard door switch to the Mv input and throw all that other stuff away. Configure 2 different moods for your 2 different modes (day/night) in the 'Automatic' tab. Job done.

Robin

[Chris Pitman]

Thanks Guys got it working when I tried before had the settings on the lighting block wrong.