Skip to first unread message
Jaro2432
Apr 9, 2020, 12:56:30 PM4/9/20
to loxone-...@googlegroups.com
I greet all members of this group and also wish everyone a lot of health in this awful time.
now to my problem.
via the Intesis Modbus Unit (INMBSTOS001R000) for Toshiba bus air conditioners, I would like to read additional data from the indoor and outdoor air conditioners to Loxone via ModBus Extension. Basic controls with fixed addresses (on / off, mode, temperature setting ...) work perfectly, but additional information (functions) does not read me from the TCC-net bus.
it is RAV Toshiba air conditioner (1x outdoor unit, 1x indoor unit and 1x remote control (bus, connected to tcc-net)).
I can see that the air conditioner responds to the "Indoor unit exist" address of 4000 and 4025 with number 1, which means "Exist", also responds to the "Indoor Unit address" command, 4001 returns 258 and 4026 returns 257.
However, the device does not respond to other commands that are important to me for diagnostic purposes.
in the Intesis unit, the dip switch SW1 is switched to RAV, the address and speed are ok.
in the Toshiba remote control, the dip switch is switched to "Follower".
if someone has experience and knows where can be a problem, it would help me a lot.
manual for intesis is attached.
now to my problem.
via the Intesis Modbus Unit (INMBSTOS001R000) for Toshiba bus air conditioners, I would like to read additional data from the indoor and outdoor air conditioners to Loxone via ModBus Extension. Basic controls with fixed addresses (on / off, mode, temperature setting ...) work perfectly, but additional information (functions) does not read me from the TCC-net bus.
it is RAV Toshiba air conditioner (1x outdoor unit, 1x indoor unit and 1x remote control (bus, connected to tcc-net)).
I can see that the air conditioner responds to the "Indoor unit exist" address of 4000 and 4025 with number 1, which means "Exist", also responds to the "Indoor Unit address" command, 4001 returns 258 and 4026 returns 257.
However, the device does not respond to other commands that are important to me for diagnostic purposes.
in the Intesis unit, the dip switch SW1 is switched to RAV, the address and speed are ok.
in the Toshiba remote control, the dip switch is switched to "Follower".
if someone has experience and knows where can be a problem, it would help me a lot.
manual for intesis is attached.
sorry for my english
Jaro
Reply all
Reply to author
Forward
0 new messages