Daylight Responsive Lighting - bug?

[Seb]

Hi, thought I would let you know of a bug that I have raised with Loxone on the new Daylight Responsive Lighting block.

Scenario

Kitchen lighting to defaul to All On that is controlled by the Daylight Responsive Lighting block

Setup

Hi, I have 15 tree RGBW spot in four lighting groups. The Lighting Groups are connected to AQ2-5 on a Lighting Controller and the Daylight Responsive Lighting block is connected on AQ1.The Daylight Responsive Lighting has the same 4 Lighting Groups connected to it (see picture).

• The lighting controller has "All On" with AQ1 at 100% to let the Daylight Responsive Lighting block controll the 4 Lighting Groups
• Motion sensor activates "All On" mode
  
• Other modes control AQ2-5 (eg each of the Lighting Groups directly)

What happens

If I upload the config to the MS, it looks to be fine as the All On mode is activated (kids in the room atm), when I cycle through the modes, the first time, it is also fine. When it cycles back to All On the Light Groups do not turn on (only a few do). If I upload the config to the MS, it looks to be fine until I cycle through the modes. The setup I am using is pretty much identical to the image in your documentation.

I tried getting a reset pulse to the to the Daylight Responsive Lighting when All On was activate but could not get the config to work. I was using AQS to check for the All On ID, but could not work out how to get a single pulse.

[Seb]

So I had it miss configured (thank you Loxone for helping me). The lighting controller output (AQ1 in this scenario) need to be a Switch, not a dimmer as I had it.

Now working fine!