RX2 DR window settings after a power cycle of device

[Gert Vestergaard Larsen]

Hi!

I have been testing the ADR functionality on a device. I have a device that is configured for an init RX2 DR setup of SF12. On the server the network initial RX2 DR setup is the same. In the ADR part of the profile for my device I have set the RX2 DR to SF10 and TX window to RX2. After my device has joined it will receive a rx_param_setup _req and change the RX2 DR to SF10.

If I do a power cycle of my device it will again use the init RX2 DR of SF12, but the server is still using the RX2 DR SF10, so the device won't receive the join_accept.

Should'nt the server go back to use the initial RX2 DR, when the device is re-joining?

/Gert