NAT on a pipeline 75...help!!!

[mdo...@my-deja.com]

Help! I can't get NAT going.

I have one valid IP address...lets say its 75.101.10.37.
I have a network with 3 computers....who's ip address are not set to
anything. Want to use the private lan ip addresses.

I can find the NAT configuration, but where the heck do you set the
base address for your fake ip addresses?

Can somebody spoon feed me on how to setup a small network using NAT?

Thanks,
-Mike

Sent via Deja.com http://www.deja.com/
Before you buy.

[Sloan]

Well basically you just need to setup your internal lan as either
10.0.0.0 network or 192.168.0.0 network. Go to your Ethernet->Nat set the
nat profile as your connection name. Make sure that its under single ip
address and dont' touch anything else. You should be set. You do want to
make sure that you have your second ip address setup under
ethernet->MOD->ethernet .. the second ip address would be like
192.168.1.1 as your router for the internal network. If you have any more
questions let me know. I know I was a bit scarce. Take care and good
luck.
,Smileyq