Airspy linrad settings

[C. Lemmi - WD6Y]

I'm setting up my IC-9700 (with Leo-Bodnar Board and PTRX-9700) with an Airspy and now I need to setup Linrad to get the signal from Airspy to MAP65 or WSJT-X for my 23 cm station.

I need to know what settings I need in Linrad for:

rate

bandwidth

gain

xtal error

real data

or a suggestion of which settings would be advisable for my setup.

U – A/D and D/A set up for RX

A-      Change input …

O- Airspy

Serial no: 0x62CC6BFF218E781

Airspy device autoselected

0         1,000,000 Hz

1         2,500,000 Hz

      Select rate by line number. _???

1

Enable bias (Y/N)?   (will send 5v. DC to the input connector, 0.5 A.

N

A = 9.0 MHx

B = 8.0 MHx

C = 7.0 MHx

D = 6.0 MHx

E = 5.0 MHx

F = 3.4 MHx

H = 2.5 MHx

I = 2.0 MHx

J = 1.5 MHx

K = 1.0 MHx

L = 0.5 MHx

Select bandwidth from table:  ???

Select gain mode.

0         = Linearity

1         =  Sensitivity

???

Enter xtal error in ppb =>

???

Use real data at 5000000 Hz (Y/N)?

???

73

Carlos Lemmi

WD6Y@ARRL.NET