LiGrip Series

See if there is no RTK configuration, in firmware V3.5.0 will not automatically configure the last

① Can't connect directly to LiBase without using 4G, the handheld RTK is a 4G module program,

Problematic path planning: continuous crossing of bushes, disorganized features, affecting overall

Operating Temperature: -20℃ ~40℃ , Storage Temperature: -40℃ ~70℃

This type of situation is generally a data problem. Three situations cause data corruption: ①

① Directly update the firmware version (recommended). ② Can be deleted through the APP bag file (not

Upgrade to the latest firmware version and format the camera disk. On Friday, November 29, 2024 at 4:

H300 Voltage: 12V-16.8V; Supply current above 4A. On Friday, November 29, 2024 at 4:35:16 PM UTC+8

There is a turn-in-place as well as a crouching motion when collecting into the interior, resulting

V7 version will not directly cause processing failure, but it will cause the following effects:

The probability that the original Video file name has been modified, the original video file is not

Time-lapse mode records at 5.7K, 2s for one frame, the final MP4 video is 5.7K, 30 fps. On Friday,

Please upgrade GreenValley APP to the latest version. On Friday, November 29, 2024 at 4:25:55 PM UTC+

Check the camera trigger mode, in the video file storage directory, open the json file generated

Set the pitch parameters Roll, Yaw and Pitch to 0. On Friday, November 29, 2024 at 4:21:08 PM UTC+8

GNSS module can be used all over the world, as long as the GNSS signal is good. On Friday, November

You need to use a USB flash drive with Type C interface. On Friday, November 29, 2024 at 4:19:21 PM

If you set up a network base station without using public CORS, you need the server to be a public IP

① The photos recorded in Result-Img are the photos filtered by the software and used for point cloud

It is not recommended, CORS do not work indoors, it is recommended to separate them. On Friday,

You can check whether the firmware is the latest version in the device management page of GreenValley

This problem may be caused by decompressing the firmware upgrade file, which can't be recognized

Firmware upgrade is not completely caused, although the firmware version has been shown as 1.4.0, but

For weak GNSS signal area, it is recommended not to deal with GNSS when processing, and only process

Generally when the card speed is insufficient, format the memory card and then test a few groups to

There are generally 3 solutions: ① Poor wifi signal ---- Camera set to Cuba mode ② Camera cache file

Not recommended, none of the lasers should be exposed to water, as water droplets can cause noise. On

Updated firmware now supports SIM in EU and SIM with PIN.

GreenValley APP has not been updated to the latest, please update the APP before updating the

October 31st of every leap year is affected due to a leap second issue. For handheld devices, upgrade