Request for Review – THERM Model Setup for Condensation Check

[Lampham]

Hello Everyone,

I have been learning THERM by myself for a while, but I am not fully confident in my results. I would greatly appreciate it if someone could help me verify whether my model setup is correct.

In my model, I am checking for condensation risk at RH = 35%, and I do not observe any condensation.
Could you please confirm if the following parameters are appropriate?

1. Interior Film Coefficient: I used the default U-factor and only changed the relative humidity to 35%.

2. Exterior Film Coefficient: I used the default U-factor and only changed the relative humidity to 35%.

3. Interior Aluminum Frame (Convection Only): I used the default settings and changed the relative humidity to 35%.

4. NFRC 100-2010 Exterior Conditions: I used the default values and only changed the relative humidity to 35%.

Please see my model version 7.8.57.0 below for your reference.

Thank you in advance for your support and feedback.

Best regards,

Lam.