Laser Cutter

[Jeromy Clements]

Anyone know whats up with the laser cutter? I'll go to run a cut and the laser moves to position and then nothing happens. I haven't been around for a bit so I didn't know if any updates were made that would affect how we begin a cut.

[Brian Adams]

Make sure to add M80 to the top of your gcode file. 

Just open it in gedit and add it on a new line at the top. 

—
Sent from Mailbox for iPhone

On Sun, Dec 29, 2013 at 3:01 PM, Jeromy Clements <jeromy....@gmail.com> wrote:

Anyone know whats up with the laser cutter? I'll go to run a cut and the laser moves to position and then nothing happens. I haven't been around for a bit so I didn't know if any updates were made that would affect how we begin a cut.

--
 
---
You received this message because you are subscribed to the Google Groups "Lansing Maker's Network" group.
To unsubscribe from this group and stop receiving emails from it, send an email to lansing-makers-ne...@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.

[Jeromy Clements]

Thank you!

--
 
---
You received this message because you are subscribed to a topic in the Google Groups "Lansing Maker's Network" group.
To unsubscribe from this topic, visit https://groups.google.com/d/topic/lansing-makers-network/PALZDbT2cMs/unsubscribe.
To unsubscribe from this group and all its topics, send an email to lansing-makers-ne...@googlegroups.com.

[mr]

Do you need to add M81 at the bottom?

[Joe Zimmerman]

I don't think so

[Brian Adams]

You don't need to. You can, but the firmware will do the m81 after the max inactive time out. 

—

Sent from Mailbox for iPhone

[Rosangela Canino-Koning]

Does laser.lmn add those yet?

-r

[Joe Zimmerman]

I think Brian updated the code last night to do that.

Joe