Skip to first unread message
Andrew Larking
May 10, 2014, 12:15:00 PM5/10/14
to kisslicer-r...@googlegroups.com
Hello.
I use an Ultimaker 2, Cura is nice but I'm wanting to try some other slicers as I hear they offer more/different tools. Kisslicer especially gets talked about a lot. However for somebody new to GCode and printing in general it is daunting to try to configure the program for the printer, ad then modify the GCode to do start and end operations. So I wonder if any UM2 owners are using KS and if they are would they be willing to share settings/advice?
Cheers.
funBart
May 11, 2014, 7:25:41 PM5/11/14
to kisslicer-r...@googlegroups.com
Maybe you can ask on the Ultimaker forum as well. There are some active Kisslicer users there too.
Bart
Reply all
Reply to author
Forward
0 new messages