You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to
Hello all, I have a problem printing with the new "extruder map" feature. As it can be seen from enclosed STL and GCODE, when it is de-string time it looks to me that the job is done twice.... and the filament feeding then keeps using negative values (= pulling out filament during print).
You do not have permission to delete messages in this group
Copy link
Report message
Show original message
Either email addresses are anonymous for this group or you need the view member email addresses permission to view the original message
to kisslicer-r...@googlegroups.com
Found the PROBLEM. If you look at the posted GCODE you will find that material setting for extruder 2 says . . ; destring_suck = 5.15 ; destring_prime = 5.25 . . BUT if you look carefully at the on screen parameter for SUCK you (hardly) notice a spurious "6" in front of 5.25... getting a whopping 65.25mm retraction !
1) My fault not to check carefully my keyboarding 2) Making for a bit wider display would help 3) Allowing a TWO digit integral value printout could harm nobody and possibly save some hairpulling :-)